The electrical connection must be made before connecting the
appliance to the power supply. The apparatus must be installed by a
qualified electrician who is fully aware of current safety and installation
regulations. The installation must be carried out in compliance with
regulations of the local electricity company. Make sure that the voltage
shown on the rating plate is the same as the power supply voltage in
your home. Regulations require that the apparatus be earthed: use
conductors of the appropriate size only. The manufacturer declines all
responsibility for injury to persons or animals and to damage to
property resulting from failure to observe the above regulations. For
the electrical connection, use a H05 RR-F cable as indicated in the table
below:
Power supply voltage.
Conductors Amount per size
230V ~ + 3 X2,5 mm
2
230-240V ~ + 3 X2,5 mm
2
(Australia only)
230V 3~ + 4 X 1,5 mm
2
400V 3N ~ + 5 X1,5 mm
2
400V 2N ~ + 4 X1,5 mm
2
Should the hob already have a power cable, see the diagram
showing the connection to the power supply in the description
sheet.
The appliance must be connected to the electricity supply by
means of a multi-pin switch with a minimum contact gap of
3mm.
Warning: the power supply cable must be long enough to allow the
cooktop to be removed from the worktop and must be positioned so
as to avoid damage or overheating caused by contact with the base.
Connecting to the terminal board
Note: the yellow/green earth wire must be connected to the terminal
with the symbol and must be longer than the other cables.
• Open the terminal board as shown on the lid (A).
• Remove approx. 70mm of cable sheath from the power supply cable
(B).
• Strip approx. 10mm of sheath from the wires. Then insert the
power supply cable into the cable clamp and connect the wires to
the terminal board as indicated in the connection diagram near the
terminal board itself.
• Secure the power supply cable (B) using the cable clamp.
• Close the terminal board with the cover (A).
• After completing the electrical connection, fit from the top and hook
it to the support springs as illustrated.
After connection to the power supply, the hob automatically performs a
function check which will take a few seconds.
Electrical connections
6
(16 Seiten)
(122 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern