KitchenAid KHIP3 90400 Bedienungsanleitung PDF herunterladen (Seite 11)

CBA

Wires Number x size

220-240 V ~ +

3 x 4 mm

220-240 V 3 ~ +

5 x 1.5 mm

380-415 V 3N ~ +

5 x 1.5 mm

380-415 V 2N ~ +

4 x 1.5 mm

380-415 V 3N ~ 220-240 V ~ 220-240 V ~ (AU and UK)

380-415 V 2N ~ 220-240 V 3 ~

(Belgium only)

380-415 V 2N ~

(NL only)

Connecting to the terminal block

Use an H05RR-F or H05V2V2-F cable for the electrical wiring as indicated in the table below.

Electrical wiring

Important:

- Based on the wiring diagram (see figure), either keep or remove the metal jumpers between the

screws on the terminal block L1-L2 and N1-N2.

- If a wire is provided, see the wiring instructions attached to it.

- Tighten all six screws on the terminal block after connecting the wires.

Examples of jumper fitted (left) or removed (right). See the wiring diagram for details (the jumpers can

be between L1-L2 and between N1-N2).

Connect the yellow/green earth wire to the terminal with the symbol.

This wire must be longer than the other wires.

1. Remove the terminal block cover (A) by undoing the screw and inserting the cover in the terminal

block hinge (B).

2. Insert the power supply cable into the cable clamp and connect the wires to the terminal block as

shown in the diagram next to it.

3. Secure the power supply cable with the cable clamp.

4. Close the cover (C) and screw it on the terminal block using the screw you removed before.

Every time the hob is connected to the mains, it will carry out an automatic check which takes several

seconds.

If the hob already has a power supply cable, follow the instructions accompanying the cable. Connect

the appliance to the mains electricity supply using a multi-pole disconnector with a minimum contact

gap of 3 mm.

230 V

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Keine Kommentare

KitchenAid KHIP3 90400 Bedienungsanleitung Seite 11