
11
Using existing pots and pans
Use a magnet to check whether pots or pans are suitable for use on the induction hob: pots are unsuitable
if they cannot be magnetically detected.
- Ensure pots have a smooth bottom, otherwise they may scratch the hob’s glass ceramic surface. Check
dishes.
- Never place hot pots or pans on the hob’s control panel. This could result in damage.
Recommended pan base diameters
XL
Ø 30 cm
Ø 14 cm 30 cm
M
Ø 18 cm
Ø 14 cm 18 cm
IMPORTANT: Refer to the “SENSOR” section for information on the correct pan base diameters for cooking
zones with the SENSOR function. If adapter plates (not provided) are used or a pan is empty, the internal
temperature of the system will exceed the set limit and the power supply to the hob will be switched o.
This happens to protect the internal components from overloading. We recommend switching o the hob
and allowing the cooking zone to cool down to the temperature at which the indicators on the control
panel switch o.
Installation
After unpacking the hob, check that there has been no damage during transport.
If in doubt, contact the dealer or After-Sales Service.
PREPARING THE HOUSING UNIT
WARNING
- Install a separator panel under the hob.
- The lower part of the product must not be accessible after installation.
- If there is an oven beneath the hob, do not install the separator panel.
• For the distance between the underside of the appliance and the
separator panel below, observe the dimensions given in the gure.
• To ensure correct operation of the product, do not obstruct the
minimum required clearance between the hob and the top of the unit.
• Cut the worktop to t before installing the hob and carefully remove any
shavings or sawdust.
• In case of installation of an oven under the hob, ensure that the oven has
a cooling system.
• Do not install the hob over a dishwasher or washing machine, as the electronic circuits could become
damaged by steam and humidity.
min 5 mm
min 20 mm
Kommentare zu diesen Handbüchern