Assembly instructions
10CONNECT THE DRAIN HOSEI. In case the drain hose is installed as shown on the models below:Unclip it from the holders marked with arrows..III. In cas
11Fit the “U” bend E, if not already installed, at the very end of the drain hose. Important: Do not fix the “U” bend to another position of the drain
12ELECTRICAL CONNECTIONUse a socket with an earth connection.Do not use extension leads or multi sockets.The electrical power cable must be replaced e
5019 106 01034Printed in Italyn08/08GB IL AE
3GBINSTALLATION GUIDE•Read this “INSTALLATION GUIDE” before operating.Keep this “INSTALLATION GUIDE” for future reference.Read the general recommendat
4PARTS SUPPLIED•Package with small items G G•Instruction for use G G•4 plastic caps (for certain models, the plastic caps are attached to the back of
5REMOVE TRANSPORT BOLTS!Important: Not removed transport bolts cause damages to the appliance.Unscrew the four screws (see arrows) with the wrench C s
6To seal the holes either:- insert the supplied plastic caps B supplied in the wide part of the hole and slide them in the direction of the arrow unti
7ADJUSTMENT OF THE FEETThe appliance must be installed on a solid and level floor surface (if necessary use a spirit level). If the appliance is to be
8CONNECT THE WATER SUPPLY INLET HOSE!If the water inlet hose is not already installed, it must be screwed to the appliance.Screw by hand the inlet hos
Kommentare zu diesen Handbüchern